CONS100 is a console suited for the management of the units of the family LIN10x or for the management of a generic unit handled through serial line RS232 or LAN.
The unit LIN10x interface is realized through keys, for driving relays, and through LED to display the state of the inputs and outputs.
The management of a generic units is realized by the Intelligent Console mode, that allows to match, for each key of the CONS100 that is pressed, a command string that will be sent to the peripheral unit.
The firmware is upgradable, via RS232, in order to follow the evolution of LIN10x family or to allow further operation modes.
|Technical Specifications CONS100|
|Relays contact for LIN105 remote inputs repetition||4 N.O.|
|Switching current||max 500 mA at 48 VDC|
|Ethernet interface||10 Base T|
|Network Protocols||UDP, TCP, ICMP, ARP|
|Data buffer size||N°2 independent of 255 bytes|
|Signals||RxD, TxD, GND|
|Serial rate||fixed 9600 baud (LIN10x console)|
|Intelligent Mode||RS232 rate 2400 to 38400 character format configurable|
|Command string||up to 20 bytes for each key|
|Mains inputs||9 VAC (with AC Adapter ADM001)|
|Power consumption||2 VA|
|Size (WxDxH)||200x100x44 mm|
|Operating temperature range||0÷45°C|
|Safety||according to EN 60065|
|EMC||according to EN 55103-1 and EN 55103-2 EN 50081 part1 and 50082 part 1|
- LAN or RS232 interface
- LAN and interface status through LED and keys
- LIN10x family handling
- Repetition by relays of the LIN105 inputs status
- Intelligent Console mode for generic units handling
- Console fully configuration via RS232
- Firmware upgradable
- Easy insertion in existing LAN
Brochure / leaflet for CONS100:
User Instruction Manual for Elpro CONS100
CE Conformity document for CONS100
Application notes for CONS100
Configuration Software for CONS100 and CNS1000
Software for Ethernet interface configuration and virtual COM management – Win 32bit
150727 Tibbo tdst-5-09-12-x86-01.zip
Software for Ethernet interface configuration and virtual COM management – Win 64bit
150727 Tibbo tdst-5-09-12-x64-01.zip
Software to upload firmware into Elpro units
Firmware updating of the Elpro devices is possible using the specific utility UPLOADER.
This software should be downloaded and installed on a PC in a Windows environment.
To perform the updating of the firmware it is necessary to connect the device to the PC serial line and therefore to perform the action (typical for every device) to put the device in UPGRADE MODE.
Then load the .hex file of the new firmware version and start uploading to the device.
At the conclusion of the updating it is necessary to turn OFF and ON again the device.
How to set the CONS100
in UPGRADE MODE
Turn the CONS100 ON keeping the key 12 pressed.
The UPGRADE MODE is signalled with the led RUN and INTELLIG. CONSOLE lighted.
Notes: A string will be sent after the device restart. The string and the delay time after restart can be programmed by the utility DSEmanager
Current release: 1.2
High Resolution Images
Download here the available Hi-Res images of CONS100.