SDZ16 is a 16×16 SD digital matrix switcher with associated analog audio.
It’s ideal for switching SD-SDI signals in video studios, production center and non linear editing suites.
Each SD input is provided with an automatic compensation and each output is reclocked.
Audio is inputs / outputs balanced type.
The matrix switcher can be commanded by integrated keyboardoard and by computer through RS232 or LAN. SDZ16 performs a synchronous switching with an analog external reference with the possibility to select the switching line (1÷16).
|Standard||From 143 to 360 Mbaud, SMPTE259M, 8 or 10 bits|
|Input coupling||AC, 75Ω|
|Inputs||N°16, with equalizer up to 200 m RG59 B/U|
|Input return loss||>18 dB at 270 MHz|
|Switching||on external reference line 6 default, selectable from 1 to 16|
|Outputs||N°16, with reclocker|
|External Synch. Reference||Analog, black burst|
|Input/output type||Differential with Phoenix screwtype removable|
|Input impedance||44KΩ differential|
|22KΩ single ended|
|Input level||17 dBm max (balanced)|
|Frequency response||-0.1 dB from 20 Hz to 20 KHz|
|Crosstalk||55 dB at 16 KHz (worst case)|
|Hum & Noise||-63 dBm unweighted (worst case)|
|Remote control||RS232, LAN|
|Mains inputs||230 VAC / 115 VAC (selectable)|
|Power consumption||20 VA|
|Size (WxDxH)||483x220x132 mm|
|Operating temperature range||0÷45°C|
|Safety||according to EN60065|
|EMC||according to EN55103-1 and 55103-2|
- Automatic rate selection from 143 to 360 Mbaud
- External switching reference
- Switching line selectable
- Command by keyboardoard, RS232 or LAN
- 16 recallable presets
- Balanced audio combined
Brochure / leaflet for SDZ16 Dual PS:
User Instruction Manual for Elpro SDZ16 Dual PS
CE Conformity document for SDZ16 Dual PS
How to control SDZ16 by CNS1000
User manual for LAN202
Application notes for SDZ16
Software to upload firmware into Elpro units
Software for Ethernet interface configuration and virtual COM management – Win 32bit
150727 Tibbo tdst-5-09-12-x86-01.zip
Software for Ethernet interface configuration and virtual COM management – Win 64bit
150727 Tibbo tdst-5-09-12-x64-01.zip
Firmware updating of the Elpro devices is possible using the specific utility UPLOADER.
This software should be downloaded and installed on a PC in a Windows environment.
To perform the updating of the firmware it is necessary to connect the device to the PC serial line and therefore to perform the action (typical for every device) to put the device in UPGRADE MODE.
Then load the .hex file of the new firmware version and start uploading to the device.
At the conclusion of the updating it is necessary to turn OFF and ON again the device.
How to set the SDZ16 Dual PS
in UPGRADE MODE
Turn the SDZ16 ON holding the key MODE pressed. The UPGRADE MODE is signaled by message ‘Upgradon the display and leds of MODE key are lighted.
Notes: Bug fixed for occasional display anomalies.
Current release: 1.1
Previous version: 1.0
High Resolution Images
Download here the available Hi-Res images of SDZ16 Dual PS.