The transceivers belonging to this family carry up to 50m a digital DVI-D signal through a CAT6 cable.
Compactness, cheapness and reliability are their characteristics.
They sink the supply directly from the DVI connection, therefore they don't need the external Power Supply.
The transceivers belonging to this family carry up to 300 m UXGA, Audio and K+M signals through a CAT5/6 cable.
Audio may be analog on stereo 3.5 mm jack or digital on RCA pin or Optical. Transmitters with 4 and 10 CAT5/6 outputs are offered and separated receiver as well. Receivers are fit up of Gain and Equalizer trimmers.
The most advanced receiver is provided of a digital skew corrector in order to obtain a perfect alignment of the RGB colours.
Most of the transmitters offer the VGA looping input to permit the monitoring of the carried signal.
The transceivers belonging to this family carry up to 600 m Composite (CV), Component (YPbPr and YcbCr) and Audio signals through a CAT5 cable.
Audio may be analog on RCA or stereo on 3.5 mm jack or digital on RCA pin (Coax).
The interface by transformer permits the de-coupling of the ground and an excellent signal to noise ratio.
The devices don't need of the external Power Supply.
The devices belonging to this family permit to eliminate the low frequency noise audible from the loudspeakers and visible on monitors due to the ground loop between source and destination.
These devices are passive and don't need of the external Power Supply.
The transceivers belonging to this family permit to carry the IP signal of a Camera or Video Server towards a PC through a Coax cable or a CAT5 cable.
The passive transceivers allow the distance of 180 m of coax cable, whereas the active transceivers allow the distance of 1,6 km of coax cable or 1 km of CAT5 cable.
Coax cable RG6 (AWG18) and AWG24 CAT5 solid are recommended.
This HExxx family of transceivers and Routing Switchers is suited to route and bring at various distances through a CAT6 cable an HDMI signal.
Some transceivers belong to the high performances category and are able to manage 48 bit deep colour and carry the HDMI signal through 100 m. of CAT6 cable. They implement the HDBaseT™ technology.
Although the transceivers work properly with CAT5E, CAT6 UTP, STP or FTP cables, to get maximum performances it's advisable to use the CAT6 AWG23 or AWG24 STP cable.
Surge Protectors is a family of devices suited to protect network and video devices from heavy EM interferences and lightning strikes as well.
They have to be installed mainly when mains cables lie close to signal cables.
This category includes all the products not mentioned in the previous families. At this time is offered a devices for managing HDMI signal conversion.